136
WaveLinx User Manual
www.eaton.com/wavelinx
WaveLinx Wireless Outdoor Lighting Control Module Cycle the power to (switch OFF 2 seconds and then ON 4 seconds) the device’s circuit twenty times.
This removes pairing for ALL devices of this type on the affected circuit.
WaveLinx Wireless Dimming Switchpack
(WSP-CA-010: 120-347VAC model)
WaveLinx Ceiling Sensor Remove the battery for exactly 5 seconds then replace. The LED should illuminate on power up and then turn
OFF. Immediately after the LED turns OFF, press the radio button ten times at 1 second intervals.
To confirm the device has left the network, after the tenth button press wait a few more seconds, then press the
radio button again. The LED should remain OFF initially and then flash slowly two times with a brief third flash.
WaveLinx Wallstations
Battery powered
Remove the battery for exactly 5 seconds then replace. Immediately, press any button ten times at 1 second
intervals.
WaveLinx Receptacle Press and hold down the manual push button for 5 seconds and then release the push button when the LED
starts flashing red or green/amber.
To Next Page
Loading...
