Eaton WaveLinx - Page 55

55
WaveLinx User Manual
www.eaton.com/wavelinx
Step 6: In the edit screen, tap the drop down in the copy section and select the name of the programmed wallstation. If desired, type a
name for the new wallstation and then tap save.
If desired, give
this wallstation a
descr
iptive name
Select the previously
configured wallstation
Tap drop down
Tap to save
Once the wallstation is saved, a message may appear briefly stating that the copy was successful.
Copy successful
message
Step 7: Repeat these steps to copy the wallstation settings to additional wallstations as needed.