Eaton XC-303-C21-001 - Page 7

2 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
2.9 Connecting local inputs/outputs................................................... 46
2.9.1 Connecting the power supply for local outputs on XC-303-…..... 46
2.9.2 Connecting outputs..................................................................... 47
2.9.3 Suppressor circuit for inductive loads.......................................... 48
2.9.4 Connecting inputs........................................................................ 48
2.9.5 Using inputs as interrupt inputs................................................... 51
3 Commissioning .......................................................................... 53
3.1 General commissioning instructions............................................ 53
3.2 USB interface activation for XC-104-… and XC-204-… devices... 53
3.3 Startup behavior XC-104-…, XC-204-…, XControl........................ 56
3.4 Program execution....................................................................... 58
3.4.1 DIP switch S1 .............................................................................. 58
3.4.2 DIP switch S2 .............................................................................. 59
3.4.3 Program start (STOP ￫ RUN)..................................................... 59
3.4.4 Program stop (RUN ￫ STOP)..................................................... 59
3.5 Power off/Interruption of the power supply................................. 60
3.5.1 Test and commissioning (Debugging).......................................... 60
3.5.2 Forcing ......................................................................................... 61
3.5.3 Reset ........................................................................................... 62
3.6 LED indicators.............................................................................. 63
3.7 Operating states when the XControl starts ................................. 65
3.8 Programs and project................................................................... 66
3.8.1 Loading programs onto the device .............................................. 66
3.8.2 Saving and deleting a boot application......................................... 67
3.9 Updating the operating system.................................................... 68
3.9.1 Updating the operating system with the Web Config Tool.......... 68
3.9.2 Updating the operating system with the XSOFT-CODESYS-3
programming system................................................................... 68
3.10 Factory resetting XC-104-… and XC-204-…................................. 71
3.11 Mass production programming through MicroSD or USB........... 72
3.12 XN300-Assist .............................................................................. 72
4 PLC configuration ...................................................................... 73
4.1 Task configuration........................................................................ 73
4.1.1 Creating a cyclical task................................................................. 74
4.1.2 Creating the event-triggered task and defining the program call. 75
4.2 System events............................................................................. 76
4.3 Multi-tasking ................................................................................ 77
4.4 Task monitoring by watchdog...................................................... 79
4.5 Limit values for memory usage ................................................... 83
4.6 Addressing inputs/outputs and marker........................................ 84
4.7 Diagnostics .................................................................................. 85
4.8 Factory reset................................................................................ 87