3 Commissioning
3.2 USB interface activation for XC-104-… and XC-204-… devices
54 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
▶ Set the IP address for the Ethernet port on the PC or the USB/Ethernet
adapter (if any) to the same number range as that of the default IP
address of the ETH0 port on the XC-104-… or XC-204-… device! If you
are connecting the device for the first time, you will only be able to do
this if you change the PC's IP address.
Changing the PC's IP address
▶ Click on the Start menu on your PC and then on Settings
▶ Click on Network & Internet.
▶ Click on "Properties."
▶ Select Internet Protocol Version 4 (TCP/IPv4) and click on the "Proper-
ties" button.
▶ In the "Internet Protocol Version 4 (TCP/IPv4) Properties" dialog box,
enter a fixed IP address for the PC. This IP address must be in the same
number range as the device's default IP address, but must not be the
same as the latter. 192.168.119.xxx, e.g. 192.168.119.100.
▶ Enter subnet mask 255.255.255.0.
▶ Confirm with OK.
▶ Switch on the power supply at the device.
▶ Open a web browser on your PC (preferably Chrome).
▶ Enter the device's default IP address into the address bar;
https://192.168.119.204:8375
The login screen will appear.
￫
Please note that Internet Explorer is not supported.
To Next Page
Loading...
