3 Commissioning
3.7 Operating states when the XControl starts
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 65
3.7 Operating states when the XControl starts
PLC and PRG are used to indicate the operating states.
–Green–
Q1…Q4
– – – There is a LOW signal at the input.
– ON – Input has a HIGH signal
POW – – – No power on X6
– ON – 24 VDC power for device present at X6
U
L
at Q1…Q4 – – – No power
– ON – Power supply present
Status
LED
Description
1) Flashes: The flashing frequency can vary depending on the transfer rate on the bus.
When there are large volumes of data, the flashing will look like a solid green light on the LED.
To Next Page
Loading...
