Eaton XN300 - 18.4 Technical data

18 Digital input/output module XN-322-8DIO-PD05
18.4 Technical data
XN300 slice modules 02/24 MN050002EN Eaton.com 118
18.4 Technical data
18.4.1 Digital inputs
18.4.2 Digital outputs
Designation
Number of channels 4
61131-2 Type1
Input voltage UE 24 Vdc maximum 30 VDC
Signal level
LOW: 0 < UE < +8 V HIGH: +14 V < UE < +30 V
Switching threshold
normally +11 VDC
Input current at UE=24Vdc normally 3.7 mA
Input delay normally 5 ms
Quantity 4
Short-circuit proof as per EN 61131-2 Yes
Power supply for digital outputs
Number of supply voltages 1 (X3, pin on connector 24)
Rated operating voltage U
e
24 Vdc
Admissible range 18 – 30 VDC
Maximum permissible total current when using a
duty factor of 100%
2A
Protection against polarity reversal
no
Voltage monitoring
Yes
Output characteristic data
„1“ signal
Output voltage (U
e
- 1V) < U
a
< U
e
Output current per channel 0.5 A
„0“ signal
Output voltage 0V
Max. output current per channel
 10 A
Switching-on delay
< 100 s
Switch off delay < 150 s
Maximum permissible total current for all channels
when using a duty factor of 100%
2A
Maximum breaking energy of outputs (inductive
load)
1 Joule/channel