23 Analog input module XN-322-7AI-U2PT
23.5 Technical data for reference outputs
167 XN300 slice modules 02/24 MN050002EN Eaton.com
23.5 Technical data for reference outputs
23.6 Measurement ranges
23.7 Filtering:
The low-pass cutoff frequency can be configured for each voltage input
channel by using the appropriate register. This cutoff frequency is specified
in Hz without any decimal places.
The following settings are valid:
Table 9 Configurable low-pass filter.
Device version
1.00 or higher 3.01 or higher
Number of channels 1
Connection points per channel 6
Reference voltage +10 V
Permissible load per potentiometer input
Max. permissible output current 2.50 mA 4.17 mA
Potentiometer 4k 2.4 k
Maximum operating temperature 0…60 °C 0…55 °C
Maximum permissible capacitive load 100 nF
Short-circuit proof Yes, maximum 1 minute
Cumulative error as a percentage of full scale value
±0.3 %
Input 1 Value representation
1 U -10…+10 V Represented as a decimal value in mV
Pt1000 -125…+850 °C 502.4…3904.8 Represented as a decimal value in
ohms with one decimal place (in 1/10
ohm)
KTY10 -50…+150 °C 1035.9…4575.3
2-6 U -10…+10V -10000…10000 Represented as a decimal value in mV
7 Pt1000 -125…+850 °C 502.4…3904.8 Represented as a decimal value in °C
with one decimal place (in 1/10 °C)
KTY10 -50…+150 °C 1035.9…4575.3
Low-pass cut-off frequency Register value Low-pass cut-off frequency Register value
Filter disabled (default) 0x0000 100 Hz 0x0064
1 Hz 0x0001 250 Hz 0x00FA
10 Hz 0x000A 500 Hz 0x01F4
25 Hz 0x0019 1000 Hz 0x03E8
50 Hz 0 x0032
To Next Page
Loading...
