Eaton XN300 - Page 267

33 Analog weigh module XN-322-2DMS-WM
33.8 Memory layout
263 XN300 slice modules 02/24 MN050002EN Eaton.com
0x5061 – 0x8xx6
SUB 02
2 RangeConfigChannel1
Measuring range configuration
for channel 1 (AI1)
Bit 0-2 GAIN 0x0108
0: GAIN 1 ( ± 120mV)
1: reserved
2: reserved
3: GAIN 8 ( ± 15mV) (default)
4: GAIN 16 ( ± 7.5mV)
5: GAIN 32 ( ± 3.75mV)
6: GAIN 64 ( ± 1.875mV)
Bit 3-15 reserved
0x5062 – 0x8xx6
SUB 03
2 MeasuringConfigChannel2
Measuring configuration for
channel 2 (AI2)
Bit 0-9 Filter depth of ADC 1–1023 (Default
= 2)
0x010A
Bit 10 0: SINC4 filter (Default),
1: SINC3 filter
Bit 11-13 Resize mode
0: Continuous conversion mode
(default)
6: System zero-scale calibration
7: System full-scale calibration
Bit 14, 15 reserved
0x5063 – 0x8xx6
SUB 04
2 RangeConfigChannel2
Measuring range configuration
for channel 2 (AI2)
Bit 0-2 GAIN 0x010C
0: GAIN 1 ( ± 120mV)
1: reserved
2: reserved
3: GAIN 8 ( ± 15mV) (default)
4: GAIN 16 ( ± 7.5mV)
5: GAIN 32 ( ± 3.75mV)
6: GAIN 64 ( ± 1.875mV)
Bit 3-15 reserved
0x5064
–
0x8xx6
SUB 05
4 ZeroScaleChannel1 Scale start value for zero point cali-
bration for channel 1
0x010E
0x5065
–
0x8xx6
SUB 06
4 FullScaleChannel1 Scale end value for zero point cali-
bration for channel 1
0x0112
0x5066
–
0x8xx6
SUB 07
4 ZeroScaleChannel2 Scale start value for zero point cali-
bration for channel 1
0x0116
0x5067
–
0x8xx6
SUB 08
4 FullScaleChannel2 Scale end value for zero point cali-
bration for channel 2
0x011A
CAN
Object
Index
Default
CAN
Mapping
EtherCAT
Object
Index
Size
(byte)
Local I/O
description
Local I/O
addresse
s