Eaton XN300 - 4.1 Status LED signals and pin assignment

4 Power supply XN-322-4PS-20
4.1 Status LED signals and pin assignment
XN300 slice modules 02/24 MN050002EN Eaton.com 32
4 Power supply XN-322-4PS-20
Power supply modules can be used to distribute the field supply voltage for
XN300 slice modules.
The targeted use of power supply modules makes it possible to ensure that
all slice modules will be properly powered and fused as required for the
application in question by segmenting the power supply into sections.
XN-322-4PS-20 modules are powered via connector X5 using the 24 and 0 V
pins. The slice modules then distribute this power to nine +24 VDC-Out
power outputs, each with its own GND output.
The power outputs are grouped and short-circuit proof, with each group
being able to deliver up to 2 A.
4.1 Status LED signals and pin assignment
Status LEDs
a X1
– 1+ 24 VDC-Out 1, power supply group 1
– 0 V GND 1, power supply group 1
– 1+ 24 VDC-Out 2, power supply group 1
– 0 V GND 2, power supply group 1
b X2
– 2+ 24 VDC-Out 3, power supply group 2
– 0 V GND 3, power supply group 2
– 2+ 24 VDC-Out 4, power supply group 2
– 0 V GND 4, power supply group 2
c X3
– 3+ 24 VDC-Out 5, power supply group 3
– 0 V GND 5, power supply group 3
– 3+ 24 VDC-Out 6, power supply group 3
– 0 V GND 6, power supply group 3
d X4
– 4+ 24 VDC-Out 7, power supply group 4
– 0 V GND 7, power supply group 4
– 4+ 24 VDC-Out 8, power supply group 4
– 0 V GND 8, power supply group 4
e X5
– 4+ 24 VDC-Out 9, power supply group 4
– 0 V GND 9, power supply group 4
– 24 VDC U
e24
input
– 0 V GND input
f 24 VDC OK LED
Figure 17: LED signals and pin assignment for XN-322-4PS-20
Module status
(24 VDC OK)
Green ON 24 VDC OK
Power supply group voltage  18 VDC
OFF No power
X1
1+
0V
1+
0V
X2
2+
0V
2+
0V
X3
3+
0V
3+
0V
X4
4+
0V
4+
0V
X5
4+
0V
24
0V
4PS
20
①
②
③
④
⑤
⑥