Eaton XV300 Series - Safety Instructions and Requirements; General Safety Basics; Personnel and Operational Requirements

2. Safety instructions
2.1 Basics
2. Safety instructions
2.1 Basics
The device has been designed according to the state of the art and all generally
accepted safety rules and standards. However, this alone cannot eliminate all potential
hazards, which is why it is necessary for you to be aware of all hazards and residual
risks.
Do not run the device unless it is in perfect technical condition. Make sure to always
operate it as specified in this document and for the intended purpose.
Follow the safety instructions for the XV300!
Thesectiononsafetyinstructionsmustbereadandunderstoodbyevery-
onewhowillbeworkingwiththeHMIpanelbeforetheactualworkisper-
formed.
NOTICE
Payattentiontothehazardseveritylevelsusedthroughoutthisdoc-
umentationwheneverahazardisindicated.Thehazardsymbolandsignal
wordusedandthecorrespondingtextwillprovideinformationregarding
thespecifichazardandhowtoavoidorpreventit.
2.2 Mandatory requirements, personnel requirements
2.2.1 Occupational safety
All generally accepted occupational health and safety rules and standards (internal and
national) must be complied with, as must be all applicable laws and regulations in the
relevant country.
2.2.2 Personnel qualifications
The personnel responsible for installation, operation, maintenance, and repairs must
have the necessary qualifications for the work they will be performing. They must be
appropriately trained and/or briefed and be informed of all hazards and risks associated
with the device.
2.2.3 Device documentation
This manual is considered an integral part of the XV300 and must always be readily
available in the device's close proximity so that users have access to it.
24
XV30012/15 MN048017 ENwww.eaton.eu