Eaton XV300 Series - Device-Specific Hazards

2. Safety instructions
2.3 Device-specific hazards
2.3 Device-specific hazards
EXPLOSIONHAZARD
Death,seriousinjury,andpropertydamagemayoccurifthedeviceis
beingusedinapotentiallyexplosive(classified)locationand,duringoper-
ation,anelectricalplug-inconnectionisdisconnectedorthedeviceis
exposedtodangerousimpactsorothertypesofdangerousmechanical
shock.
Use the device in the following environments only:
Non-hazardous (non-explosive) areas
Zone 22 hazardous areas (according to ATEX Directive)
Make sure that the device is not exposed to dangerous impacts and other
types of dangerous mechanical shock.
Do not operate the device in hazardous (classified) locations unless it is moun-
ted correctly.
De-energize the device before disconnecting plug connections.
EXPLOSIONHAZARD
LITHIUMBATTERY
ThelithiumbatteryinsidetheXV300mayexplodeifhandledincorrectly.
Dispose of the XV300 unit professionally.
CAUTION
DESTRUCTION
TheXV300shouldonlybeopenedbythemanufacturerorbyanauthorized
center.OperatetheXV300untilonlywiththeenclosurefullyclosedand
sealed.
CAUTION
ELECTROSTATICDISCHARGE
Donottouchcomponents(e.g.,connectorpins)thatareelectrostatic-sens-
itive.
Discharge any static electricity from your body before touching the HMI panel
(e.g., by touching an earthed metal object).
Electrostaticdischargesmaydamageorruinassemblyparts.Becauseof
this,itisnecessarytotakeprecautionswheneverhandlingthecards.
Pleaserefertotheguidelinesforelectrostatic-sensitivecomponentsformore
information(ESDguidelines).
CAUTION
INTERFERENCES
Thevaluesspecifiedinthetechnicaldata,aswellasthedevice'selec-
tromagneticcompatibility(EMC),cannotbeguaranteedifthefollowingare
used:unsuitablecables,improperlyassembledandterminatedcables,
and/orwiringthatdoesnotconformtotheapplicablestandards.
Onlyusecablesassembledandterminatedbyprofessionals.
Thecablesbeingusedmustbeassembledandterminatedasrequiredby
theport/interfacedescriptioninthisdocument.
WhenwiringtheXV300TouchPanel,followallinstructionsregardinghow
XV30012/15 MN048017 ENwww.eaton.eu
27