Eaton XV300 Series - Rear (Panel) Mounting; Figure 17: M4 X 12 Weld Studs Onto the Sheet; Figure 18: Dimensional Drawing for Mount

3. Installation
3.3 Mounting
3.3.3 Rear (panel) mounting XV-313
This mounting method is intended for use with sheet metal with a wall thickness of d =
1.5 mm (0.059") ± 0.1mm (0.004") (including any coatings on the sheet metal)
Make the required mounting cutout.
Weld all the M4 x 12 weld studs onto the sheet as shown in the dimensional draw-
ing for mounting
Figure 17: M4 x 12 weld studs onto the sheet
Not a true-to-scale template! If necessary, make your own template based on the dimensional drawing
for mounting and the right scale.
Figure 18: Dimensional drawing for mountingXV-313-70-..
XV30012/15 MN048017 ENwww.eaton.eu
39