Eaton XV300 Series - List of Figures

List of figures
Figure 1: Front side with plastic bezel 18
Figure 2: Service side with optional interfaces 18
Figure 3: Front side with plastic bezel 18
Figure 4: Service side with optional interfaces 18
Figure 5: Front side with aluminum mounting
frame 18
Figure 6: Service side with optional interfaces 18
Figure 7: Front side with aluminum mounting
frame 18
Figure 8: Service side with optional interfaces 18
Figure 9: Interfaces 20
Figure 10: Example for a nameplate 23
Figure 11: Space required to remove the SD
card 31
Figure 12: Cooling air circulation 32
Figure 13: Mounting distance 32
Figure 14: Mounting position 33
Figure 15: Pre-installing the holding brack-
etsInternal hexagon M4x25 DIN 914 galvanized 37
Figure 16: Mounting the XV-303 37
Figure 17: M4 x 12 weld studs onto the sheet 39
Figure 18: Dimensional drawing for mount-
ingXV-313-70-.. 39
Figure 19: Dimensional drawing for mount-
ingXV-313-10-.. 40
Figure 20: Mounting XV-313 40
Figure 21: Screwing the functional earth con-
ductor onto the enclosure 43
Figure 22: Connecting the screw terminals on
the Plug connector MSTB 2.5/3-ST-5.08 44
Figure 23: Power supplied through Plug con-
nector MSTB 2.5/3-ST-5.08 44
Figure 24: Interfaces included on all HMI panels 48
Figure 25: XV300 Touch Panel with all optional
features 48
Figure 26: USB 2.0, not galvanically isolated,
plug type A, Full power (500 mA) 50
Figure 27: USB 2.0, not galvanically isolated,
plug type B 50
Figure 28: RJ-45 socket, 8-pole, 2 LEDs
(CAT5e/6), LAN1, 10/100 Mbps 51
Figure 29: Bus segment with four nodes 54
Figure 30: CAN bus segment with four nodes 56
Figure 31: Profibus bus segment with four
nodes 58
Figure 32: SmartWire-DT® power connector 59
Figure 33: WAGO plug connector (view from wir-
ing side) 60
Figure 34: Commissioning SmartWire-DT®
sequence 62
Figure 35: Dimensions for 7.0" front mounting
devices in mm (inches) 70
Figure 36: Dimensions for 10.1" front mounting
devices in mm (inches) 71
Figure 37: Dimensions for 7.0" rear (panel)
mounting devices in mm (inches) 72
Figure 38: Dimensions for 10.1" rear (panel)
mounting devices in mm (inches) 73
Figure 39: Installation panel for XV-313-70-.. 74
Figure 40: Installation panel for XV-313-10-.. 74
91
XV30012/15 MN048017 ENwww.eaton.eu