Eaton XV300 - Interfaces to Peripheral Devices

1. Description
1.5 Interfaces to peripheral devices
1.5 Interfaces to peripheral devices
The interfaces featured by your XV300 will depend on theXV version selected and can-
not be modified.
The nameplate will indicate which specific interfaces are included with the unit.
⑤ ⑨
①
⑥ ⑦
⑩
④
②
③
⑧
Figure 11: Interfaces
Basic interfaces (all XV300 models come with these interfaces)
 interface type
①
SD card slot
SDSC or SDHC conforming to the SDA 2.0 specification
②
USB Host USB 2.0, not galvanically isolated, plug type A, Full power (500 mA)
③
USB device USB 2.0, not galvanically isolated, plug type B
④
Ethernet 1 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100 Mbps
⑤
COM1 RS-232, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
⑥
COM2 RS-485, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
⑦
CAN CAN1, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
Optional interfaces
⑧
Ethernet 2 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100 Mbps
⑨
Profibus Profibus DP, not galvanically isolated, SUB-D socket 9-pole, UNC nuts for
interlocking
⑩
SmartWire-DT 4-pin WAGO connector (article no. 734-104) and 8-pole ribbon cable plug
XV30004/19 MN048017ENwww.eaton.eu
21