Eberspächer EasyStart Select Installation Instructions

10 | VEHICLE HEATERS – TECHNICAL DOCUMENTATION
3 STARTUP / CONFIGURATION
INITIAL STARTUP
For the initial startup, the following steps must
be carried out one after the other.
APPLYING THE OPERATING VOLTAGE
The operating voltage is applied by inserting
the 5 A fuse into the fuse holder.
After applying the operating voltage the fol-
lowing display appears:
 
Water heater
display
Air heater
display
Note: The EasyStart Select checks which type
of heater is connected and configures the
Menu bar (automatic detection).
CONFIGURING THE EASYSTART SELECT
The EasyStart Select must be configured
according to its use.
PLEASE NOTE!
These installation instructions describe
the standard configuration. For details of
enhanced configuration of the EasyStart
Select and special functions, you can view
and download the “Special Functions and
Diagnosis” installation instructions from
www.eberspaecher-standheizung.com/down-
load.
OPENING THE VEHICLE WORKSHOP MENU
Display ON, the Start display appears.
Start display
water heater
Start display
air heater
Press button
and at the same time
for longer than 5 sec.
The following display appears:

Eberspächer EasyStart Select Specifications

General

Brand	Eberspächer
Model	EasyStart Select
Category	Control Unit
Language	English