To Next PageTo Next Page
Need help?Do you have a question about the EBS LX30B-Q40T and is the answer not in the manual?
General| Category | Cell Phone |
|---|---|
| Model | LX30B-Q40T |
| RAM | 4GB |
| Storage | 32GB |
| Battery | 5000 mAh |
| Display | IPS LCD |
| Memory | 4 GB RAM |
Details on connecting the LX30B-QxT communicator to various terminals.
Wiring diagram and instructions for connecting to DSC control panels.
Wiring diagram and instructions for connecting to Paradox control panels.
Wiring diagram and instructions for connecting to Honeywell control panels.
Step-by-step guide for configuring Honeywell Vista control panels.
How to configure input sensors for the communicator.
How to start a new configuration for devices.
How to read settings from the device into the configuration software.
How to send settings and configuration to the device.
How to update the device's firmware using the bootloader.
How to configure different connection methods for the software.
Highest level access code for programming and remote control.
Code for restricted access to specific device parameters.
PIN code required for SIM card operation and system launching.
Settings related to power loss reporting and network watchdog.
Configuration options for wired inputs, including response type and mode.
Chooses output operation mode (always on/off or time-defined).
Defines conditions that can activate or deactivate outputs.
Defines specific output behavior based on various events.
Defines baud rate, parity, data bits, stop bits, and flow control.
Selects data transmission protocol (ContactID, SIA).
Sets the AES encryption key for secure data transmission.
Configuration for cellular network communication.
Defines profiles for mobile network operators.
Sets default parameters when no operator profile is found.
Step-by-step guide for programming the device locally.
Steps for the initial programming of the device with GPRS/OSM.Server.
