Ebtron GP1 - Page 4

IG_GPIG_P_INT_R1A


EBTRON, Inc. 1663 Hwy. 701 S., Loris SC 29569 • Toll Free: 800.2EBTRON (232.8766) • Fax: 843.756.1838 • www. EBTRON.com
GP1/HP1/SP1 DUCT & PLENEM PROBES - INTERNAL M OUNT
QUICK INSTALLA
T
ION G UIDE
a measurable difference!
EBTRON
®
4

Figure 2. Standard Internal Mount Probe Mechanical Detail

• • •
FINAL ASSEMBLY FOR STANDARD PROBES*
* Note: The following instructions apply to Standard probes. For AIR IQ Probes, see separate
AIR IQ FINAL ASSEMBLY instructions that follow, and refer to Figure 3.
NOTE:
3.75 in. (95.25 mm)
5.25 in. (133.35 mm)
1.50 in.
38.10 mm
Overall Duct Size
(including internal insulation)
Gasket
Gasket
4.00 in.
(101.60 mm)
Washer
Lock nut
0.375 in. (9.52 mm) x 1.50 in. (38.1 mm) Stud
Insertion side bracket
Terminal end bracket
1.00 in.
(25.4 mm)
0.75 in.
(19.05 mm)
1.1 in. (27.94 mm) dia. tube
[8.00 in. (203.20 mm) to 192.00 in. ( 4876.80 mm) long]
0.75 in. ( 19.05 mm) dia. sensor opening
1 to 4 sensors/probe
Cable
0.188 in. (4.78 mm)
Mtg. Holes (4)
5.25 in. (133.35 mm)
Airflow
Insertion Side Bracket
0.375 in. (9.53 mm)
1/2 in (12.70 mm)
0.50 in. (12.70 mm)
4.00 in (101.60 mm)
4 in (101.60 mm)
Terminal End Bracket
0.375 in.
(9.53 mm)
0.75 in. (19.05 mm)
5.25 in. (133.35 mm)
0.188 in. (4.78 mm)
Mtg. Holes (4)
Figure 2. Standard Insertion Mount Probe Mechanical Detail
NOTE:
Set
-s
screws
f
for
s
sensor
i
inserts
o
on
p
probes
m
must
a
always
f
face
d
downstream
i
in
a
airflow.
STANDARD
P
PROBE
INSERTION
M
MOUNT
BRACKET
D
DETAIL
STANDARD
P
PROBE
INSERTION
M
MOUNT
INSTALL
D
DETAIL
Mounting
S
Screws
8
8
R
Req’d
(4/ Bracket
F
Field
S
Supplied)
P R E S S
NOTE:
Probes under 18 in (45 7. 2
mm) are not equipped with
the terminal end bracket,
and therefore do not require
a mounting hole on the
opposite side of the duct.
1 to 8 sensors per probe