Installation Instructions
Camera/Monitor System
The EC7000-QK Camera and Monitor Kit from ECCO is designed
to provide a driver with video and audio from up to four cameras (kit
is supplied with one EC2014-C) individually or together on a split
screen for ultimate driver awareness. When properly installed and
used in conjunction with vehicle mirrors, ECCO’s EC7000-QK assists
drivers during hazardous parking and backing situations. This manual
provides information about installation, function, safety, maintenance,
replacement parts and warranty.
Failure to install or use this product according to manufacturers recommendations may result in property damage, serious injury, and/or death to
those you are seeking to protect!
WARNING!
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are essential to ensure
the safety of you and those you are seeking to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing,
which can cause personal injury and/or severe vehicle damage, including re.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output performance of the
system is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system without losing
eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle operator
should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks or compartment doors), people,
vehicles or other obstructions.
Do not install and/or operate this safety product unless you have read and understand the safety information
contained
Specications:
Monitors EC7003-QM 7” LCD Monitor
Image 7” LCD Color, 16:9
Controller 4 Camera
Voltage 12-24VDC
Power Consumption 25 W Max
Mirror Imaging Yes (via Camera and Monitor Switch)
Split Screen Feature Yes
AV Compatible Yes
DVR Compatible No
Audio Yes
Contrast/Brightness Yes
Light Sensor Day/Night Auto Dim
Camera Selection 1-4 Via Trigger Wires
Connection: CAM Female 4 Pin Threaded
Connection (Monitor Pigtail) Male 22 Pin
Connection: CB N/A
Housing Plastic
Mounting
Permanent - HD (2 bracket options
provided)
Mech. Vibration
Pedestal Bracket - 3G
Cradle Bracket - 8G
Weight 1.26 lbs
Dimensions (WxHxD) 7.21”x5.04”x1.24”
Operating Temp 4°F to 158°F
Remote Control Yes
Approvals FCC, CE, RoHS
Installation, Wiring and Function
Caution! When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines,
vehicle upholstery, etc. that could be damaged.
Camera EC2014-C
Image
1/3” CMOS PC1089 Color
Effective Pixels: 725 x 488
Voltage Requirement 12V
Power Consumption 3 W
Lens F=2.8mm / F=2.0
Lens Angle 120°
Audio Yes
Light Sensor Auto Switch B&W
Infrared LEDs 11 (10M Max. Visibility)
Pigtail Connection: CAM Male 4 Pin Threaded
Housing Aluminum Alloy
Mech. Vibration 10g
Mounting Rear/Front
Dimensions (WxHxD) 2.87”x2.99”x2.60”
Operating Temp. -22°F to 158°F
IP Rating IP69K
Approvals FCC, CE, C-Tick, E13/R10
Current Consumption 175mA Max
To Next Page
Need help?
General
