ECG FS 91 T - Page 35

GB
35
USE
Make sure prior to each use that the fan is in good condition and the power cord is not damaged. The appliance
must not be used when the power cord is damaged.
The function of the fan can be controlled using either the buttons on the control panel or the remote control.
You have to point the remote control at the control panel. Before you use the remote control insert acoin
battery (CR2032 3V). Keep proper polarity of the battery. If the appliance is not used for long periods, remove
the battery from the remote control.
Connect the unit to the power supply with corresponding voltage and frequency (220V ~ 240V, 50Hz).
Button functions:
(The buttons on the remote control have the same function as the buttons on the appliance)
ON/SPEED 2
Start the appliance by pressing ON/SPEED. After turning it on you can use other functions/buttons. You can
use this button to set the air ow speed during operation. Press to switch speeds in the following order: low ->
medium -> high -> low -> etc.
TIMER 1
Press TIMER button to enter the timer setting mode.
At factory setting there is no set timer period. You can set period 1h, 2h, 4h, 8h by pressing this button. The set
period is indicated on the display. After the set time passes the appliance goes into standby mode.
MODE 5
When you press the MODE button, you switch operation modes in following order: normal -> summer -> night
-> normal ->etc. LED indicates the current mode.
NORMAL: the device runs according to current setting and constant fan rotations.
SUMMER: the motor will work automatically in alternating cycles of high-medium-low rotations as shown on
the following diagram.
High
Medium
Low
High
Medium
Low
High
Medium
Low
NATURAL mode at high rotations
NATURAL mode at medium rotations
NATURAL mode at low rotations
NIGHT: Press MODE button to light up the relevant LED for night mode.
In this mode, the fan switches on and o in the set speed and saves energy during the night.
1. If upon starting the Sleep mode the fan is set to high speed, the fan runs rst 5 seconds at high speed and
then for additional 5 seconds switches to medium speed, then for further 5 seconds switches to low speed.
The entire cycle repeats itself until the preset time is completed or until the appliance is switched o.