ECG KT 10 - Page 30

GB
30
to 8 years old may not insert the plug into the outlet, regulate and
clean the appliance or perform user’s maintenance.
Do not immerse in water!
WARNING:
This heater is not equipped with a device for measuring the
room temperature. Do not use the heater in small rooms
occuppied by individuals that are not capable of leaving
the room without assistance, unless proper supervision is
available.
CAUTION:
Some parts of this product can become very hot and cause
burns. Special attention has to be paid in the presence of
children and handicapped people.
DO NOT COVER!
WARNING: To prevent overheating, do not cover
theheater.
OPERATING INSTRUCTIONS
When you rst turn the ceramic heater on, you may detect aslight odour. This is not amalfunction. This is
common with most heaters, it is harmless and it disappears in alittle while, after dust or grease residue, which
settled there after alonger period of inactivity or during the manufacturing process, burns o.
Controls
While observing the above safety instructions, plug the heater in asuitable electrical outlet and switch it on.
Functions switch
Position Functions
OFF O
FAN Only fan, heating o
I Low heating output
II High heating output
Using the device as afan
1. Turn the functions switch to FAN position. The fan will blow air into the room at room temperature.
2. If the fan does not switch on, that means that the temperature in the room is lower than was set as
aswitching o temperature for the built-in thermostat. Turn the thermostat control clockwise, until the
fan starts.
3. Once the fan starts, the LED indicator on the front of the device will light up.