22
EN
2. Installation of the whisks / kneading hooks
A) Insert the whisk into the small opening.
B) Install the hooks as follows: insert the hook with the washer into the larger opening and
the other into the smaller opening.
It is not possible to install the hooks in the opposite confi guration. (see pic. 1 point 3)
NOTE: Make sure that the whisks or hooks are fully inserted into the correct openings,
otherwise the mixing results could be affected.
NOTE: You can always only use a single accessory at a time.
FIND OUT ABOUT YOUR MIXER.
Pic. 1
1 Speed control / Whisk removal button
2 Turbo button
3 End parts (of the stainless steel hooks for dough, whisks), designed for insertion into the
openings
Close up of the control panel
To Next Page
Loading...
