22
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table
above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name
of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.
com.
Refer to your Chain Saw Safety Manual for kick guard application information.
Chain anD GuiDe baR Combinations
The following combinations may be used on CS-301, CS-341 or CS-346.
WARNING DANGER
Use of replacement saw chain and/or guide bar other than that specied, or operation without the “tip guard” in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard when tested on
the representative sample of chain saws below 3.8 C.I.D., and the Echo guide bar specied.
To Next Page
Loading...
