Echo shindaiwa PB-8010 - Replacing Ignition Switch

IGNITION SYSTEM
PB-8010, EB810
18
3-6 Replacing ignition switch
If ignition switch is damaged, the entire control
cable assembly (G) must be replaced.
Removing
1. Disconnect primary wire (A) and ground wire (B)
(Refer to 3-5 Inspecting ignition switch).
2. Disconnect throttle cable end (c1) from carbure-
tor.
3. Remove four screws (D).
4. Remove handle grip half (E).
5. Disconnect throttle cable end (c2) from throttle
trigger (F).
6. Pull control cable assembly (G) with cable con-
nector (H) and bolt (J) out from the handle grip.
7. Pull control cable assembly (G) out from the
cable connector (H).
A
c1
Control cable assembly
D
E
c2
c2
F
H
G
J
G
H
B
G