98
Assembly / Operating Instructions
1. To attach the mattress base in the low position.
3. Locate and hand fasten all four 35mm cot bolts loosely.
4. Once all four bolts are located begin tightening them.
2. Place mattress base inside the cot frame. Secure the mattress
base as outlined below.
Warning: Do not over tighten the bolts. Over tightening bolts
may cause panels to crack.
2. Transfer all four lling bolts to the high position holes from the
low position holes.
3. It is easier to assemble the mattress base if you place the cot on
it’s side.
4. Secure the mattress base as outlined above.
Assembly / Operating Instructions
To attach mattress base - High Configuration
Warning: Do not over tighten the bolts. Over tightening bolts
may cause panels to crack.
To attach mattress base - Low Configuration
1. To attach the mattress base in the high position.
To Next Page
Loading...