Need help?Do you have a question about the ECO-WORTHY LIFEPO4 12V 150Ah and is the answer not in the manual?
General| Nominal Capacity | 150Ah |
|---|---|
| Terminal Type | M8 |
| Case Material | ABS |
| Charging Voltage | 14.4V-14.6V |
| Float Voltage | 13.5V~13.8V |
| Charging Temperature | 0°C to 45°C |
| Discharging Temperature | -20°C to 60°C |
Details BMS protections like over-voltage, under-voltage, and short circuit triggering/recovery conditions.
Recommends installing the battery in a clean, cool, dry place with sufficient airflow.
Lists recommended equipment for installation: protective gear, insulated tools, multimeter, cables, charger.
Instructs to check for visible damage, clean terminals, verify polarity, and use proper circuit protection.
Provides a table for copper cable gauge sizes and their ampacities for handling expected loads.
Explains how to connect batteries in series and parallel, including warnings and recommendations.
Details how to tighten cable connections using insulated tools and the correct number of washers.
Recommends using LiFePO4 specific chargers or lead-acid chargers, noting potential undercharging.
Advises using solar panels with a LiFePO4/Li-ion compatible controller for charging.
A table showing the relationship between battery voltage and its actual capacity percentage.
Provides solutions for common issues like failure to fully charge or capacity issues.
Addresses common user queries regarding battery operation and care.
Explains that vehicle alternators may not provide sufficient voltage for full charging.
Lists precautions to prevent leakage, heat generation, explosion, and damage.
To Next Page
