Setup Menu>Finish #3.4
Current Product: LT ClearlySoft
1. Change Bleach
2. Change Product Factor
1. CHANGE FINISH
Setup Menu>Change Finish #3.4.1
1. Navi-Sour
2. Navi-Soft
3. Navi-Sour IC
4. LT Sour
5. LT Clearly Soft
6. LT IC Sour
5. LT CLEARLY SOFT
Submenu #3.4.2 Setup Menu> Finish >Change Product Factor:
Change the selected finish product factor.
Press SK#3 <Save> to save selection. Press <Back> to cancel selection.
Setup Menu>Finish #3.4
Current Product: LT ClearlySoft
1. Change Finish
2. Change Product Factor
2. CHANGE PRODUCT FACTOR
Setup Menu>Finish>Change Product Factor #3.4.2
2 5 1 6 4 8 4 2 4 6 5 7 4 9 0 0 6 7
(Use Left/Right/Up/Down to change)
2
2.3.5 Submenu #3.5 System Menu>Optional Form Select:
The optional Formula Select module is required to activate this feature. Default setup is Yes.
When FS is installed, formulae can be selected using the module on the front of the washers using the
Up/Down/Enter keys. The FS screen will display any system errors.
If no formula select is installed, formulae must be selected from the Condor Controller. In this case, it is advised the
controller be mounted in a central location convenient for accessing – or set up the washers in MicroMode for
automatic formula selection (Refer to Installation Manual).
Use Up/Down arrow keys to highlight a selection.
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
System Menu #3.0
1. Washer Settings
2. Detergent
3. Bleach
4. Finish
5. Optional Form Select
6. Optional Solid Product4
7. Optional Liquid Product
8. Select Textile Type
9.Reset Setup Menu
10. Reset All
5. OPTIONAL FORM SELECT
Setup Menu >Optional Form Select #3.5
1. No
2. YES
2. YES
2.3.6 Submenu #3.6 System Menu>Optional Solid Product4:
Enable an optional solid forth product. Default setup is No.
Use Up/Down arrow keys to highlight a selection.
Press SK#3 <Save> to save selection.
Press <Back> to cancel selection.
To Next Page
Loading...
