5 Functional description
You must strictly observe the additional components manufacturer's operating
instructions that have been supplied.
The Lubo-DryExx applicator stations
®
are devices for the automatic supply of DryExx®
belt lubrication plants with belt lubricant.
The complete system comprises the Lubo-DryExx applicator station
®
in combination with
the control unit DryExxEco
®
Advanced-ETH.
The system is used for dosing DryExx
®
belt lubricant products and is used via the control
unit DryExx®
®
Advanced-ETH for up to 16 lubrication circuits in a total 10 plants.
5.1
Description of the DryExx
®
system
The DryExx
®
system consists essentially of an applicator station with a diaphragm
compressed air pump, a control unit as well as the standard piping and nozzle system.
Various types of control unit are available dependent upon the size and specification of
the installation.
The standard supply and piping system is produced in stainless steel, but PE piping is
available as an option.
The distribution circuit is in line with the requirements of the installation and where it is
sited, but essentially is a wet lubrication system.
NOTICE!
The number of nozzles per lubrication circuit is max. 50 – 60!
The standard nozzle system has welded nozzle fittings. For conveyors with more than two
tracks, the number of tracks - 1 is used to calculate the number of nozzles.
The inserted nozzles have a throughput of approx. 3 litres per hour at a spray pressure of
0.2 MPa (2 bar). In order to prevent leakage over time from the nozzles, ball-bearing valve
filters with an opening pressure of 0.14 MPa (1.4 bar) are used.
Functional description
Description of the DryExx® system
29 Rev. 02-09.2017
To Next Page
Loading...
