Ecolab Lubo-DryExx - Archive Data Display Details; Circuit Parameter Access; Area Selection for Parameters; Circuit Selection for Parameters

417101634_Lubo-DryExx_Advanced
- 43 -
Rev. 07-01.15
7.3.3.1.1.1.1 Archive display
fig. 7.8
This screen displays the following information:
• Circuit number
• System number
• Sequential valve number
• Selected archive
• Consumption values
• To leave the ‘Archive for Circuit xx’ screen:
 Press "ESC"
OR
• To go to “Monthly archive part 2
 Press Button ""
OR
• To go to the ‘Start’ screen:

Press " "
If you leave the screen using the ‘Back’ button, the archive ‘Circuit Selection’ screen appears
again.
7.3.4 Circuit Parameters
fig. 7.9
• To go to the ‘Circuit Parameters’ screen:
 Press ‘Circuit Parameters’
7.3.4.1 Area selection
fig. 7.10
The screen only displays Area if the valves are
allocated.
• To go to the “Area Selection”
 Press "Area xx"
• To leave the “Area selection“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
Press " "
After leaving the picture with button „Back “you see again the „Main Screen”.
7.3.4.1.1 Circuit selection
fig. 7.11
The screen only displays Area if the valves are
allocated.
• To go to the “Parameter display”
 Press "circuit xx"
• To leave “Circuit selection“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Back“ you see again the Parameter „Area selection”.