Ecolab Lubo-DryExx - Change Valve and Booster Times; Change Valve Times

417101634_Lubo-DryExx_Advanced
- 44 -
Rev. 07-01.15
7.3.4.1.1.1 Parameter display: Change Valve- and Booster-times
fig. 7.12
The picture shows the following items:
 Circuit and area number (area)
 Total valve number of the system
 Pulse- and break-time (default and actual)
 Actual state of „Booster“
 Actual state of release
 Change the Valve-times:
 Press Button "Valve Times"
 Change the Booster-times:
 Press Button "Booster Times"
 Leave the picture:
 Press Button “Return”
OR
• To go to the ‘Start’ screen:

Press " "
After leaving the picture with button „Return“ you see again the Parameter - „circuit selection”.
7.3.4.1.1.2 Parameter display: Change Value Valve-times
fig. 7.13
The picture shows the following items:
 Circuit and area number (area)
 Total valve number of the system
 Pulse- and break-time (default)
 Change parameters:
 Press Values and input value (Password)
 Leave the picture:
 Press Button “Return”
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Return“ you see again the Parameter - „Valve and Booster-
times”.