Ecolab Lubo-DryExx - Message Display Information; System Logout Procedure; Accessing General Parameters; General Parameter Display Details

417101634_Lubo-DryExx_Advanced
- 46 -
Rev. 07-01.15
7.3.5.1 Message displays
fig. 7.16
The following messages are indicated:
 Fault messages (must be acknowledged)
 Operating signals
 HMI-System messages
 Result of diagnostics
 Scroll in the messages
 Use the scroll-bars
 Leave screen
 Press "Back"
7.3.6 Logout
fig. 7.17
• To reset of actual password
 Press "Logout"
7.3.7 General Parameters
fig. 7.18
• To go to the “General Parameters”
 Press "Para. Generaly"
7.3.7.1 Displays of Parameter Generaly
fig. 7.19
The display contains the following announcements:
• Time relief pump
• Time pre tension system
• Time delay of empty signal
• Pulse width of optional oval gear meter (OGM)
• To change variables
 press variable
• To go to “operation mode”
 Press "operation mode"
• To go to “unit counter”
 Press "unit counter"
• To leave “Parameter Generaly“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Back“ you see again the “Main Screen”.