Ecolab Lubo-DryExx - System Operation Modes; System Monitoring Screen; Unit Counter and Pulse Width

417101634_Lubo-DryExx_Advanced
- 47 -
Rev. 07-01.15
7.3.7.1.1 Operation modes
fig. 7.20
The display contains the following announcements:
• Active operation mode
• To change operation mode
 Press desired operation mode button
 Switch on control dosing amount
• To leave “Operation mode“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Back“ you see again the „General Parameters”.
7.3.7.1.2 Monitoring
fig. 7.21
The display contains the following announcements:
• Actual metering value
•
Desired metering value
•
Metering deviation positive [%]
•
Metering deviation negative [%]
•
Metering value positive [%]
•
Metering value negative [%]
•
To the other valves (metering circuits)

Press „“ Button

Press „“ Button
•
To configure the desired metering value

Press „“
OR
• To go to the ‘Start’ screen:
 Press " "
7.3.7.1.3 Unit counter
fig. 7.22
The display contains the following announcements:
• Pulse width of optional unit counter/area
• To change pulse width
 Press button for desired area „units per puls“
• To leave “Unit counter“
 Press ‘Back’
OR
• To go to the ‘Start’ screen:
 Press " "
After leaving the picture with button „Back“ you see again the „General Parameters”.
NOTE
All system attitudes are exclusively alterable by technical personnel and are not more
near described.