1
！
Unpacking operation
After you receive the TOYDIY 4in1 3D Printer, please open the box
according to following the steps. Each machine has been strictly
tested and packaged before leaving the factory. Please be careful
during unpacking.
Grasp two Zip tie to hold the machine with your both hands, and
gentlytake TOYDIY 4in1 3D Printer out of the box. Be careful not
to directly grasp the guide rail of X axis so as not to damage the
machine.
当您收到易立创 TOYDIY 4in1 3D Printer 时，请按照步骤开箱。每台机器
在出厂前都进行了严格测试及包装。请开箱时务必小心操作。
两手分别抓住固定机器的其中两条扎带，从两边抓取机器，把 TOYDIY
4in1 3D Printer 从箱子中缓慢取出。
快速开箱
开箱
Unpacking
取出机器
Take out the machine
注意 : 不要直接抓 X 轴导轨，以免损伤机器。
Note:Do not grab the X-axis guide rail directly to avoid damage to the machine.
Note: Please do not use too much force when taking the machine out of the carton, so as not to
damage the machine. The toolhead flat cable is not a handle. Do not pull or twist the toolhead flat
cable at any time.
注意：把机器从纸箱中拿出来时请不要太用力，以免损伤机器。工具头排线不是把手，在任何时候
都不要拉扯或扭曲工具头排线。
！
To Next Page
