SE-601 Series Electrocardiograph Service Manual Electrocardiograph Disassembly
- 55 -
5) Disassembly Procedures of the Display Screen for SE-601B/C
Remove the four cross recessed tapping screws to separate the LCD screen and the display screen
frame, as the following figure shows.
3. Disassembly Procedures of the fuse
To replace the blown fuse,
1) Unplug the electrocardiograph from AC power. Pull out the AC power cord from the AC
power connector on the rear of the electrocardiograph.
2) Locate the AC fuse, which is directly below the AC power connector, as the picture shows:
理邦保密文件
EDAN CONFIDENTIAL
To Next Page
Loading...
