7
Quick Start Guide | Glowplug
unit diagram
2 3 4 5
1 7
8
1. 1/4” Jack Socket Output - connect to amplifier
equipment here.
2. Warmth - adjust how much warmth (tube gain) is
applied to your sound using this control.
3. Crossover - balance where the overall warmth is applied
to your sound using the crossover control.
4. Mix - adjust how much of your signal goes through the
Tube element of the pedal, turned fully clockwise all of
your signal will be going through the tube in the pedal.
5. Volume - use this control to adjust the
output volume of the pedal.
6. ON/OFF - switch your Glowplug on or off here.
7. 1/4” Jack socket input - connect your instrument to the
pedal here.
8. Power input - input your power supply here, included
with your Glowplug pedal.
6
To Next Page
Loading...
