OPERATION
1. Unpack the Fan gently.
2. Remove the protective foam and plastic bag and save it for future use.
3. Place the Fan on a rm and level surface.
4. Connect the DC plug into the Fan.
5. Plug the AC plug of the power supply into the 110V wall socket.
6. The Fan will automatically blow in the level 1 setting.
7. Press the Fan Speed setting to adjust the fan speed from level 1 to level 4.
Level 1: fan LED 1 on
Level 2: fan LED 2 on
Level 3: fan LED 3 on
Level 4: fan LED 1, 2 and 3 all on
8. Adjust the Timer to turn the Fan off after 1-6 hours, or manually turn off.
Timer 1 LED ON: setting 1 hour
Timer 2 LED ON: setting 2 hours
Timer 3 LED ON: setting 3 hours
Timer 1&3 LED ON: setting 4 hours
Timer 2&3 LED ON: setting 5 hours
Timer 1&2&3 LED ON: setting 6 hours
9. Adjust the Fan to the desired angular air output direction.
10. Holding the Fan power button for three seconds will turn off the Fan.
The fan will memorize the current Fan Speed setting. When it comes
back on it will start in the recorded setting.
CLEANING AND STORAGE
Turn the Fan off and unplug it before cleaning.
Use only a soft cloth or cotton swabs to gently wipe the Fan clean.
DO NOT immerse the Fan in water and never allow water to drip into the motor
housing.
DO NOT use gasoline, paint thinner or other chemicals to clean the Fan.
For storage, clean the Fan carefully as instructed. Store the Fan in the original
packaging or cover the Fan to protect it from dust.
WARNING
ANY REQUIRED SERVICE OTHER THAN ROUTINE CLEANING SHOULD ONLY BE PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE
IMPORTANT
SAVE THESE
INSTRUCTIONS
To ensure you get the best results from
your Fan, please read this manual rst
and keep it for future reference. For
additional information, please contact
your place of purchase or call
1-800-225-6595
Thank you for choosing EdenPURE
®
©2017 EdenPURE® I-5433 BR11619R-1
360 Air Fan
Model: A5728
To Next Page
Need help?
General