15
Test program
1) To Start: Close the door and press start/reset button, then press the Power button and the machine
will enter the test program. Every control LED will light and blink with the frequency of 1Hz. Press the
start/reset button again and the wash process lights will blink from left to right.
2) During the test program the machine can skip to the next step by pressing the start/reset button
except during the water inlet step.
3) During the test program press the start/reset button or open the door and the machine will stop (all
the wash process lights will stay on.) When the start/reset button is pressed again or the door is
closed the machine will continue automatically.
4) During the test program all ten error tests must be validated.
5) Once testing is over, all the lights turn off and a tone will sound.
To Next Page
Loading...
