16
Replacing System Components
Warning:
Always turn off the electrical power supply before servicing any electrical component or replacing any
parts. All voltage checks should be made with a voltmeter having a full scale range of 130 volts or higher.
After service is completed, be sure all grounding and electrical circuits are connected and secure, and all
access panels are in place.
Control panel
The control panel allows the user to select the various cleaning cycles and operate the dishwasher. All
electrical elements in the dishwasher are controlled by the control panel.
Removal and Replacement
1. Disconnect the electrical supply from the dishwasher.
2. Open the dishwasher door.
3. Remove the 6 screws that connect the control panel cover to the dishwasher door.
4. Close the dishwasher door.
5. Release the door latch and allow the control panel cover to hang against the dishwasher door.
6. Remove electronic controller out from the control panel.
7. Disconnect the wire terminals from electronic controller.
8. Replace new controller and reverse procedures to complete installation.
To Next Page
Loading...
