EdgeStar CWR1101DZ - Page 13

- 13 -
3. DISASS
EMB
LY
2. Push up the top insert Assembly. (figure 47)
Figure 47
3.
Unplug the cable connector. (figure 48)
Figure 48
4. Loosen six screws. (figure 49)
Figure 49
5. The display board is like below. (figure 50)
Figure 50
6. Loosen four screws.
7. Press the plastic nail supporting the control board with
forefinger and thumb. (figure 51)
Figure 51
8.
Unplug all cable connectors.
9. The control board is like below. (figure 52)
Figure 52
(Models：CWR1551DD )
1. Loosen four screws. (figure 53)
Figure 53
Screw
2. Pull out the electrical box. (figure 54)
Figure 54
3. Loosen the two fixer from PCB board. Take out the PCB
board.(figure 55)
Figure 55
3. The display board is like below. (figure 56)
Figure 56