25
Replacing the Stainless Steel Flexline
1) Remove the rear louver cover.
2) Unscrew the exline retaining nut and pull it out of the square hole.
Tools Needed:
• Phillips Screwdriver • #22 open-end wrench • #14 open-end wrench
3) Unscrew the Phillips screws on the left and right sides of the control panel as well as the screw
that axes the gas manifold on the right side of the rebox.
4) Pull the gas manifold assembly slightly forward to expose the gas burner valves.
5) Uscrew the exline nut at the gas burner valve.
6) Remove and replace the exline.
7) Follow the above instructions in reverse to reinstall the new exline.
To Next Page
Loading...
