How to Configure AR-7288WnA on MAC
Configuration Steps
A. Hardware Installation
1. Connect the ADSL line
Connect the Line interface of the device to the Modem interface of a splitter using a telephone cable.
Connect a telephone to the Phone interface of the splitter using a telephone cable. Connect the Line
interface of the splitter to your existing, incoming line.
The splitter has three interfaces:
Line: Connect to a wall phone jack (RJ-11 jack).
Modem: Connect to the ADSL jack of the device.
Phone: Connect to a telephone set.
2. Connect the power adapter to the router
Plug one end of the power adapter into a wall outlet and connect the other end to the 12V interface of
the device.
The following diagram shows how to correctly connect the router, PC, splitter and the telephone sets.
3. Check the ADSL LED status
Please check the ADSL LED on the front panel. This light indicates the status of your ADSL broadband
through your telephone line. If the light is on, you can continue setup. However if the light is flashing,
there is no broadband line detected. Please call your Internet Service Provider (ISP) and inform them
about the flashing ADSL light to resolve the issue.
Note: You must use the power adapter included in the package with the router, do NOT attempt to use a
third-party power adapter.
To Next Page
Need help?
General
