Refresh – Refresh adapter list in the “B“ block.
Mode – There are two modes: Station and Access
Point. If “Station“ is selected, the adapter works as a
wireless adapter. If “Access Point“ is selected, the
adapter will works as a wireless AP.
View – Enable “Status Bar“ and the “D“ block in the
utility will display the current status of the utility.
About – To check the version of the utility, select this
item.
Show Tray Icon – To show the icon in the system tray,
select the item.
Disable Adapter – This function is for you to disable or
enable the adapter.
Windows Zero Config – To configure the adapter from
To Next Page
Loading...
Need help?
General
