3
LED Status
Power: Green LED
- Off: power off or fail
- On: power on
10/100Mbps port LED: 2 LEDs per port, on RJ45 jack
Link/Activity: Amber LED
- Off: port disconnected or link fail
- On: port connected
- Blinking: sending or receiving data
PoE status: Green LED
- Off: PoE power off
- On: PoE power on
10/100/1000Mbps copper port: 2 LEDs, on RJ45 jack
- Off: port disconnected or link fail
- Green on: 1000Mbps connected
- Amber on: 10/100Mbps connected
- Blinking : sending or receiving data
-
SFP: Green LED
- Off: port disconnected or link fail
- on: 1000FX connected
- Blinking : sending or receiving data
Operating Environment
This switch must be installed and operated within the limits of the specified
operating temperature 0 - 40°C (32 - 104°F) and humidity (10 - 90%
non-condensing).
- Do not place objects on top of the unit.
- Do not obstruct any vents at the sides of the unit.
- Do not position the unit close to any heating source such as a heater,
radiator or in direct exposure to sun.
- Take care to ensure the unit does not come into contact with water.
Consider using a dehumidifier to reduce humidity and prevent moisture
entering the unit.
To Next Page
Loading...
Need help?
General
