To Next PageTo Next PageWhat to do if no image is output from my Edirol Mixer?
If no image is being output from your Edirol Mixer, consider the following: * Ensure the [OUTPUT FADE] fader is raised. * Verify you've selected an appropriate input channel using the INPUT SELECT buttons. * If the [FADE] button is blinking, use the [CONTROL] fader to fade the image of bus A. * Confirm that the correct video format (NTSC or PAL) is specified for the input signal.
Why is the image distorted on my Edirol Mixer?
Image distortion on your Edirol Mixer can occur due to several reasons: * The level of the synchronization signal from your video equipment might be too low; try adjusting the “Video Sync Threshold” in the “Utility” menu. * The video format (NTSC or PAL) might be incorrectly specified; ensure it matches the input signal. * If you've recently switched PC inputs using the [PC INPUT SELECT] switch, allow some time for the input to stabilize. * If you are using the INPUT SELECT buttons, perform the suggested operations or settings to allow smooth transitions between images without switching noise.
What to do if the video fader on my Edirol Mixer isn't changing the image?
If operating the video fader on your Edirol Mixer isn't changing the image, it could be because the same image is selected for both bus A and bus B. Select different images for each bus.
Why does the image on my Edirol Mixer change automatically?
If the image on your Edirol Mixer is changing automatically, check if the [BPM SYNC] button is lit. If it is, press the [BPM SYNC] button to turn off its illumination.
Why aren't the menu settings saving on my Edirol Mixer?
Menu settings on your Edirol Mixer are saved to the internal memory when you close the menu. Ensure you are closing the menu before switching off the power.
What to do if I can’t change the settings in a memory on my Edirol Mixer?
If you're unable to change the settings in a memory on your Edirol Mixer, check if memory protect is turned 'On'. If it is, turn the “Memory Protect” setting “Off” in the “Utility” menu.
General
