Instruction manual
EN
REF.: 07694
Cordless Vacuum cleaner
· When storing or cleaning the vacuum
cleaner, if you need to disassemble the
electric brush, please hold down the brush
and turn the screw on the back of the
brush, and then pull the electric brush in
the direction of image 3 which shown, -
nally remove it from the mounting hole.
Use
Vacuum load
When the power of the vacuum is low,
charge it until the charging time runs out.
When the voltage is too low (to protect the
battery) the vacuum will turn off automati-
cally to protect it.
Before charging, always make sure that
the handheld vacuum and base assembly
is well installed and stable.
Connect the plug of the charging power
cable to the AC outlet. If the charge indica-
tor is “blinking circularly”, it indicates that
the vacuum is charging.
After charging about 4 hours, when the
three charging indicator lights are on, it
means that the battery of the vacuum is
fully charged. The indicator lights will turn
off automatically three minutes after full
charge. Unplug it from the AC outlet.
Use of electric brush
The electric brush can be used on short-hai-
red carpets or hard oors, tiles, etc.
Note: What happens if the electric brush
is blocked as protection? If, when using
the electric brush, sucking too much ber
will result in the loss of the rolling brush
and will automatically turn off to pro-
tect the personal and motor safety of the
brush.
image 1
image 2
image 3
To Next Page
Loading...