Item: 1632874
Model: ERL772472W4
4-LEVEL WELDED STEEL STORAGE RACK
77"W x 24"D x 72"H
Helpful Items for Assembly (not included)
Edsal Manufacturing Company, LLC products are guaranteed for a
period of one (1) year from the date of purchase. The SOLE AND EX-
CLUSIVE REMEDY for such defects is the repair or replacement of a
defecve product or parts thereof by Edsal Manufacturing Company,
LLC or, at Edsal Manufacturing Company, LLC opon, refund of the
purchase price upon return of the item to Edsal Manufacturing Com-
pany, LLC. This warranty shall not apply in the event the products are
damaged as a result of misuse, neglect, accident, moisture, improper
applicaon, improper assembly, or assembly not in conformity with
the instrucons of Edsal Manufacturing Company, LLC, failure to
abide by safety precauons prescribed by Edsal Manufacturing Com-
pany, LLC or modicaon or repair by persons not authorized by
Edsal Manufacturing Company, LLC.
Warranty
Contents
Descripon Quanty Part Number
A: End frame 2 ERFR2472-BLK
B: Beam 8 ERBM72-BLK
C: Tie Channel 12 ERTBV624-BK
D: Wire Deck 4 2472W-S
Hardware Kit:
Includes (16) canoe clips (E), (24) bolts (F), (24) nuts (G)
General Instrucons
Before beginning assembly, read through all instrucons and
make sure all parts are present. Assembly of this unit is done by
ng the inside bracket tabs of the beam ends into the post
slots of the end frames. The bracket tabs should engage and t
rmly into the tapered slot of the post frame. This engagement
is a ght swaged t and will apply resistance as it fully engages.
A visual inspecon should be made to show that the bracket is
properly engaged in the slot.
A rubber mallet should be used on the ledge of the beams to
properly seat the beam bracket tabs. If a hammer is used care
should be taken to protect the beam surface to avoid damage by
using a protecve cloth or block of wood.
The stepped surface of the beam ledge is the top, and should
face upwards. This is the surface that the wire deck will rest on.
The beam will have small rounded holes on the top ledge and
long sloed holes on the boom ledge. The long sloed holes
will be used to secure the e channel to the beams.
Aer assembly re-check each beam for proper engagement.
Safety Instrucons
Follow these instrucons carefully, failure to do so can result in
property damage or personal injuries. Cauon: contains small
parts, keep children away during installaon. This unit should be
placed on a level surface. Failure to do so can result in poor
product performance or create a possible safety hazard. This
unit should be securely anchored to a wall or oor with suitable
fasteners, not included.
DO NOT STAND ON ANY PART OF
THE UNIT, OR USE IT AS A LADDER.
DO NOT MOUNT CASTERS TO THIS
UNIT. DO NOT USE THIS UNIT TO
STORE AQUARIUMS.
Use care when working with metal
parts. Wear gloves for protecon.
Do not exceed the maximum weight capacity of 1,500 lb. (kg)
per shelf (not to exceed 6,000 lbs for the enre unit). Always
evenly distribute the weight on each level and keep the heavier
loads on the boom.
Do not use this unit for anything other than the manufacture’s
intended purpose. Keep this manual for future reference.
B: beam
D: wire deck
Rubber Mallet,
Screwdriver, Wrench,
Gloves
C: e channel
A: end frame
E: canoe clip
G: nut
F: bolt
To Next Page
Need help?
General
