© Edwards Limited 2007. All rights reserved. Page 9
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
D357-25-880 Issue E
4 Operation
4.1 Pressure measurement
For most accurate pressure measurement the procedure in Section 5.1 should be used to zero the gauge.
If you connect the ASG to an Edwards ADD or AGC display/controller, the pressure measured by the ASG is shown on
the display.
If you connect the signal output of the ASG to a voltmeter, convert the measured voltage to the corresponding
pressure value using the following formula:
Pressure = Full scale
x Voltage
10
To Next Page
Loading...