Edwards STP-XA3203BV155 - Accessories

STP Series Turbomolecular Pump
MT-00E-1B1-C
Page 56
SERVICE, SPARES AND ACCESSORIES
8
8.4 Accessories
The following is a list of accessories that can be purchased by contacting Edwards.
Items
Application purpose
Remarks
Instruction Manual (A)
*1
Generic Instruction Manual
This manual
Instruction Manual (B)
*1
Pump Specific Information
Instruction Manual (C)
*1
Control unit Instruction Manual
applicable to your STP pump
Instruction Manual (D)
*1
For STC-U eTMS unit
Power cable
*2
Primary input power
Standard cable length is 5 m
(max. 30 m). Contact Edwards
for further information.
STP connection cable
*2
Connection cable between the STP
pump and the STP control unit
TMS sensor cable
*2
Connection cable between STC-U and
temperature sensor of STP pump
Shielded cable.
Standard cable length is 5 m
(max. 30m).
Contact Edwards for further
information. The cable type
varies depending on STP pump
to be connected. Refer to
Instruction Manual (B).
TMS sensor branch
cable
*2
Connection cable between STC-U and
the TMS heater sensor connector, the
outlet port heater sensor connector of
STP pump
Outlet port heater cable
*2
Connection cable between STC-U and
outlet port heater of STP pump
TMS heater cable
*2
Connection cable between STC-U and
TMS heater of STP pump
TMS valve cable
*2
Connection cable between STC-U and
TMS valve of STP pump
TMS valve
*2
TMS valve controls the cooling water
in order to maintain a constant
temperature inside the STP pump
STC-U remote branch
cable
*2
Connection cable which branches to
IO remote signal of STP control unit
and communication signal for STC-U
Shielded cable.
STC-U remote cable
*2
Connection cable between STC-U
remote branch cable and STP control
unit
Shielded cable.
Standard cable length is 5 m
(max 30m).
Contact Edwards for further
information.
*1 STP pump consists of the three-volumed Instruction Manuals.
*2 Optional accessory (Each accessory must be ordered separately)