Automatic modes:
After 7 seconds of remote control inactivity, automatic
mode is activated by the motion sensor built
inside the remote control.
The white cycling signal flashes when you’re cycling
normally.
If you are standing still or break suddenly, the motion
sensor built inside the remote control will
automatically trigger the the flashing hazard signal.
If there is no motion/remote control activity after 26
seconds the LED display and remote control will go into
standby mode.
To re-activate the LED display, slide the remote control
button in any direction.
While using an e-bike
With an e-bike the motion sensor may not detect
movements in automatic mode. We recomend you use
the manual control mode with any e-bike.
To Next Page
Loading...