Eggtimer Proton Quick Start Guide
Power: 7.4v/2S LiPo, 300 mAH or higher recommended. Bigger is Better…
Connect to the two BATT terminals, RED generally goes to "+" and BLACK to "-"
Deployment Power:
Any battery that will operate your deployment device is OK..
For SINGLE battery, jumper B+ and DP+
For DUAL batteries, connect: “+” of deployment battery to DP+
“-“ of deployment battery to DP-
Do NOT use the B+ pad
Output Modes:
OFF: Turns the channel off
Drogue: Fires the channel at some time past nose-over
Main: Fires the channel at some altitude on the way down
Airstart: Fires the channel at some time on the way up
Clustered: Fires the channel when the clustred-to Airstart channel fires
See Appendix C for use with servos in Drogue & Main modes
WiFi Connection
Select the “Proton_xxxxx” SSID, and use the passkey that was on the WiFi module’s
envelope (you did save it, right?), or recover the passkey using the data cable (see
Appendix E for instructions)
Set your browser to 192.168.4.1 to open the Status Page…bookmark it for later use!
Status Page
Displays:
SSID
Status (Disarmed, normally)
Validation Code (for arming)
Channel Summary/Status
Battery Voltage
ASL altitude
Accelerometer reading in G's (with link to Calibration page)
Temperature in F
To Next Page
Loading...