56-VOLT LITHIUM-ION POWER HEAD — PH1400/PH1400-FC20
To remove battery pack (Fig. 6)
WARNING:
Always be aware of the
location of your feet and children or pets
around you when pressing the battery-
release button. Serious injury could result
if the battery pack falls. NEVER remove
the battery pack at a high location.
1. Hold the battery pack in the palm of
your hand.
2. Press the battery-release button with your thumb; the battery pack will disengage
from the latch.
3. Grasp the battery pack and remove it from the power head.
WARNING: To avoid serious personal injury, always remove the battery pack and
keep hands clear of the lock-off button and trigger when carrying or transporting the
tool.
STARTING/STOPPING THE
POWER HEAD (Fig.7)
WARNING:
NEVER OPARATE THE
POWER HEAD WITHOUT AN ATTACHMENT.
Do not attempt to start the power head
without an attachment.
To start the power head
1. Press the lock-off button down and
hold it in that position. Depress the trigger to turn on the power head. Release the
lock-off button and continue to squeeze the trigger for continued operation.
2. The rotational speed of the tool is controlled with the variable-speed trigger.
More pressure on the trigger results in higher speed; less pressure on the trigger
results in lower speed. Adjust the speed to suit the task at hand.
NOTICE: The motor runs only when the lock-off button and trigger are both pressed.
6
Press to release
7
High/Low-Speed Switch
Lock-off Button
Trigger
To Next Page
Loading...
Need help?
General
